TerryWhite Chemmart Pulse Oximeter 1 each^ (always read the label)
^ Always read the label and follow the directions for use.
The TerryWhite Chemmart Pulse Oximeter measures oxygen saturation and pulse rate. It has an easy-to-read two colour OLED display screen, 4 different display orientations, has a low battery indicator and comes with batteries and a protective case.
1. Insert batteries 2. Check parameter settings 3. Insert finger fully into rubberised hold of the pulse oximeter with the nail surface facing upwards. 4. Release the clamp and press the power button to turn on the device. Device will turn off after 8 seconds if finger is not detected in the device.
Please read safety information and warnings listed in the manual provided with the product. Carefully read the manual regarding safety information, operation and specifications before using this pulse oximeter. • Do not leave this device unattended in the vicinity of children or pets. • Do not attempt to open or service the pulse oximeter. Only qualified service personnel should attempt any servicing required. • Do not use this device in clinical environments where an alarm is required. Although this oximeter provides an alarm function it does not meet IEC60601-1-8 standard. • The specified environmental temperature should be between 5°C~40°C. Transport and storage temperature: - 10°~+40°C. When the ambient temperature is low or high, ensure that the product has acclimatised to room temperature before use. • It is not suitable for long term continuous patient monitoring. Continual measurement must not exceed 2 hours. Do not change location during measurement. The transfer of blood oxygen saturation and pulse rate data value oximetry takes about 8-10 seconds and the data update cycle around 20 seconds. • Sp02 measurements may be adversely affected in the presence of elevated levels of ambient light. Shield the sensor area from direct sunlight if necessary. • The following reasons will cause interference: - Other high-frequency electrosurgical devices. - The placement of a sensor on a digit affected by a blood pressure cuff arterial catheter or intravascular line. - The patient has hypotension, severe vasoconstriction, severe anaemia or hypothermia. - The patient is in cardiac arrest or is in shock. - Fingernail polish or false fingernails may cause inaccurate Sp02 readings. WARNING: EXPLOSION HAZARD - Do not use the pulse oximeter in a flammable atmosphere where concentrations of flammable anaesthetics or other materials may occur. WARNING: Degraded sensors and electrodes may affect performance or cause other issues. WARNING: Do not attempt to recharge normal dry-cell batteries, they may leak, cause a fire or even explode. WARNING: Do not use the pulse oximeter in an MRI or CT environment. CAUTION: Keep the operating environment free of dust, vibrations, corrosive or flammable materials, extreme temperature and humidity. CAUTION: When not in use for extended periods of time, remove the batteries from the battery compartment. CAUTION: Do not operate the unit if it’s damp or wet. Avoid using the equipment immediately after moving it from a cold environment to a warm, humid location.
N/A